r-software
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
| r-software [2018/11/18 07:00] – aorth | r-software [2019/01/25 11:29] – [Information] aorth | ||
|---|---|---|---|
| Line 4: | Line 4: | ||
| ===== Information ===== | ===== Information ===== | ||
| - | * Version: 3.5.1 | + | * Version: 3.5.2 |
| * Added: February, 2015 | * Added: February, 2015 | ||
| - | * Updated: | + | * Updated: |
| * Link: https:// | * Link: https:// | ||
| Line 15: | Line 15: | ||
| Load one version into your environment and run it: | Load one version into your environment and run it: | ||
| - | < | + | < |
| $ R</ | $ R</ | ||
| Line 23: | Line 23: | ||
| Notes from the sysadmin during installation: | Notes from the sysadmin during installation: | ||
| - | < | + | < |
| - | $ tar xf R-3.5.1.tar.gz | + | $ wget https://cran.r-project.org/ |
| - | $ cd R-3.5.1 | + | $ tar xf R-3.5.2.tar.gz |
| + | $ cd R-3.5.2 | ||
| $ sudo yum install gcc-gfortran gcc-c++ libX11-devel libXaw-devel bzip2-devel libcurl-devel xz-devel readline-devel | $ sudo yum install gcc-gfortran gcc-c++ libX11-devel libXaw-devel bzip2-devel libcurl-devel xz-devel readline-devel | ||
| - | $ ./configure --enable-R-shlib --prefix=/ | + | $ ./configure --enable-R-shlib --prefix=/ |
| $ make -j4 | $ make -j4 | ||
| - | $ sudo mkdir -p / | + | $ sudo mkdir -p / |
| - | $ sudo chown aorth:aorth / | + | $ sudo chown aorth:aorth / |
| $ make install | $ make install | ||
| - | $ sudo chown -R root:root / | + | $ sudo chown -R root:root / |
| $ sudo yum remove gcc-gfortran gcc-c++ libX11-devel libXaw-devel bzip2-devel libcurl-devel xz-devel readline-devel</ | $ sudo yum remove gcc-gfortran gcc-c++ libX11-devel libXaw-devel bzip2-devel libcurl-devel xz-devel readline-devel</ | ||
r-software.txt · Last modified: 2023/07/12 06:39 by aorth