Differences

This shows you the differences between two versions of the page.

--- backup:amanda:server_installation [2012/06/11 12:03] – [Configure] aorth
+++ backup:amanda:server_installation [2012/06/11 12:05] (current) – aorth
@@ Line 75: / Line 75: @@
 <code>sudo su - amandabackup
-amcheck taurus</code>
+amcheck daily</code>
 Other than errors about tape labels, the command should work fine.
@@ Line 81: / Line 81: @@
 === Setup a disklist ===
-Set up a "disklist" for the new config in ///etc/amanda/taurus/disklist//.  For now, just do something like so we can test quickly:
+Set up a "disklist" for the new config in ///etc/amanda/daily/disklist//.  For now, just do something like so we can test quickly:
 <file>localhost	/etc	root-tar</file>
@@ Line 91: / Line 91: @@
 <code>mtx load 1
-amlabel taurus taurus-01 slot 1 -f</code>
+amlabel daily daily-01 slot 1 -f</code>
 === Run a test backup ===
@@ Line 98: / Line 98: @@
 <code>sudo su - amandabackup
-amdump taurus</code>
+amdump daily</code>
 === Test recovery ===
@@ Line 118: / Line 118: @@
 <code>amrecover> exit</code>
-The restore might take a few minutes because the drive has to spool to the location of the file on the tape.  Be patient!
+The restore might take a few minutes because the drive has to spool to the location of the file on the tape.  Be patient!  The contents of the restore will be found in whichever directory you started the restore from, ie ///tmp/restore// above.
 === Delete the temp tape ===
@@ Line 125: / Line 125: @@
 <code>sudo su - amandabackup
-amrmtape taurus taurus-01</code>
+amrmtape daily daily-01</code>
 === Label more tapes ===
@@ Line 133: / Line 133: @@
 <code>sudo su -
 mtx unload
-for tapenum in {1..4}; do mtx load $tapenum; amlabel taurus taurus-0$tapenum slot $tapenum -f; mtx unload $tapenum; done</code>
+for tapenum in {1..4}; do mtx load $tapenum; amlabel daily daily-0$tapenum slot $tapenum -f; mtx unload $tapenum; done</code>