apcupsd
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
apcupsd [2009/08/26 09:12] – 172.26.0.166 | apcupsd [2011/09/02 12:42] (current) – aorth | ||
---|---|---|---|
Line 2: | Line 2: | ||
The HPC's head node is connected to an APC battery backup unit which has a USB cable that can be used for monitoring power status. The [[http:// | The HPC's head node is connected to an APC battery backup unit which has a USB cable that can be used for monitoring power status. The [[http:// | ||
- | ===== Configuration ===== | + | |
+ | ===== Installation (RPM) ===== | ||
+ | Download pre-compiled RPMs for Enterprise Linux 5 from the EPEL project: http:// | ||
+ | |||
+ | ===== Installation (manual) ===== | ||
+ | Download source from: http:// | ||
+ | |||
+ | < | ||
+ | cd apcupsd-3.14.7 | ||
+ | ./configure --enable-usb --enable-cgi | ||
+ | make | ||
+ | sudo make install</ | ||
+ | |||
+ | ===== Configuration | ||
==== Daemon ==== | ==== Daemon ==== | ||
Line 8: | Line 21: | ||
After the software is installed, there are two files which need attention: | After the software is installed, there are two files which need attention: | ||
- | === / | + | ==== / |
- | Make sure to list the the localhost and give it a name. This is used for remote monitoring and also for checking the status via the multimon CGI script: | + | Make sure to list the the localhost and give it a name. This is used for remote monitoring and also for checking the status via the multimon CGI script: |
< | < | ||
# | # | ||
Line 30: | Line 43: | ||
MONITOR 127.0.0.1 " | MONITOR 127.0.0.1 " | ||
- | === / | + | ==== / |
- | The defaults are ok, but make sure the daemon is configured to use '' | + | The defaults are ok, but make sure the daemon is configured to use the following settings (leave '' |
- | < | + | < |
+ | UPSTYPE usb | ||
DEVICE</ | DEVICE</ | ||
- | ==== Web monitoring interface ==== | + | ==== Web monitoring interface |
+ | |||
+ | The '' | ||
+ | |||
+ | Copy the CGI scripts: | ||
+ | < | ||
+ | $ sudo cp multimon.cgi upsimage.cgi upsstats.cgi / | ||
+ | |||
+ | Check the status by visiting http:// | ||
+ | |||
+ | ===== Startup ===== | ||
+ | Add the daemon to the default runlevels: | ||
+ | < | ||
+ | |||
+ | ===== Testing ===== | ||
+ | Make sure the daemon is stopped, then run: | ||
- | The '' | ||
===== Troubleshooting ===== | ===== Troubleshooting ===== |
apcupsd.txt · Last modified: 2011/09/02 12:42 by aorth